Catalog

The Qbus Dali Sensor is a combined passive infrared (PIR) motion detector and a light sensor, and connects directly to the DALI bus. The DALI sensor (QDSEN) is suitable for installation at a height of 2.5m with a detection range of 7m in diameter.

The Qbus Dali Sensor High Bay is a combined passive infrared (PIR) motion detector and a light sensor, suitable for installation at a maximum height of 15 meters with a detection range of a 40-meter diameter.

DIN-rail Module to connect the Qbus system with a DALI (2) system (max. 64 addresses). Supports RGB(W) and WWCW on DALI (DT8). Allows for easy control and visualization of a DALI system via the familiar Qbus control panels (switches, detectors, Cloud, EQOmmand ...).

DIN rail module to dim 2 DALI lighting circuits, without programming. Dims up to 64 DALI devices distributed over 2 DALI circuits. Operated via standard push buttons, including an All Off and Panic button. The module can be used both stand-alone and in combination with a controller (Full Qbus)

DIN-rail stand-alone Qbus Dali Group Dimmer for 4 groups with built-in power supply, supporting up to 64 DALI(2) drivers. With this Qbus DALI Group Controller, you can easily control up to 4 lighting groups on a single DALI bus. The module can operate both in stand-alone mode and with a Qbus controller. It features four buttons on the front for operation of the groups and configuration in stand-alone mode. The module is also equipped with an ECO relay, allowing the power supply to be cut off in systems where this is possible.

In the SENPACK LEVEL, the entrance module INA02 is combined with the Qbus 4-20mA liquid level meter to detect water or fuel levels between 5cm and 300cm. The measured values can be translated into a 0-100% value, thermostat mode, or when other granular data is needed, the universal mode can also be applied. Available with 1 or 2 liquid level meters.