Qbus 10.9" Ipad frame

• Function description

  The QFRAME109 (white or black) is a tablet holder that consists of an aluminum finishing frame and an iron bracket in which an iPad can be mounted. 

  There are various generations of iPads compatible with this tablet holder: 

  • iPad 10th generation (2022)
  • iPad Air 4th, 5th, and 6th (2024) generation
  • iPad Pro 1st, 2nd, 3rd, and 4th generation

  The finishing frame is attached by hooking it over the bracket on one side. Due to the built-in magnets in the finishing frame, it then aligns flush against the bracket. As a final step, it can be fixed on the other side using an adjustment screw.

  The power supply for the iPad can be provided through a separately ordered in-wall USB adapter (QFRAME/USB).

• Technical specifications

  General specifications:

  • Finish frame made of aluminum, finished with powder coating RAL9003 (white) or RAL 9011 (black)
  • Mounting bracket made of iron, finished with powder coating RAL7021

  Physical specifications:

  • Aluminum finish frame
  • Protection rating: IP20, EN 60529
  • Installation: screws and plugs
  • Dimensions (h x w x l): 280mm x 195mm x 11mm
  • Weight: approximately 100g.
• Sizing
• Explanation of symbols

  Equipment where protection against the risk of electric contact is not only based on basic insulation but also on additional protection such as double insulation or reinforced insulation. There is no possibility for grounding.

   

  Before connecting the device, it is mandatory to read the manual of the respective product. ISO7000-0434

  Power supply connection (230V) to the power supply connector. IEC 60417-5036

  CE conformity. All declarations of conformity are available upon request.

• Warranty provision

  Standard Warranty Period: 2 years from delivery date.

  The warranty is no longer valid if the module has been opened! 

  Defective modules should be sent without seal along with a description of the defect to our service department:

  QBUS N.V.

  Joseph Cardijnstraat 19

  9420 Erpe-Mere

  Belgium

  T +32 53 60 72 10

  F +32 53 60 72 19

  Email: support@qbus.be

   

General

• Safety Instructions

  Read the complete manual before installing and activating the module.

  WARNING

  • Carefully choose the location where the tablet holder will be placed. Do not place it in direct sunlight to prevent the tablet from overheating.
  • Follow the recommendations of the tablet manufacturer.
  • The QFRAME and QFRAME/USB must be installed and maintained by a certified electrical installer in accordance with the applicable legal regulations of the country.
  • Before working on the QFRAME and QFRAME/USB, the power supply must be turned off.

Installation and wiring

• Installation

  Preparation:

  The frame can be mounted horizontally or vertically. Mark the holes to be drilled, drill the holes, and install the anchors.

  Mounting bracket:

  Attach the wall bracket with the supplied screws and, after securing it, adhere the black self-adhesive circular bumpers over the screws.

  Ipad Installation:

  If the Ipad is an Ipad Pro or an Ipad Air, attach the included self-adhesive transparent buffers at the specified location.

  Next, connect the supplied USB cable to the iPad and place the iPad screen-down in the finishing frame.

  Hook one side of the finishing frame with the iPad over the hook of the bracket and turn the holder towards the wall. The magnets will draw the finishing frame flat. Secure the finishing frame using the included adjustment screw.

• Power Supply

  The power supply of the iPad can be provided through a separately ordered wall-mounted USB adapter (QFRAME/USB).