Surface-mounted housing sensor range

• Function description

  The SENTube is a universal surface-mount housing, designed for the sensor range (*see technical data below for compatible sensors). This solution allows for easy ceiling or wall mounting of sensors when flush installation is not possible or desired. It provides ample space for wiring and connections, while ensuring quick and reliable installation. This makes the SENTube the ideal solution for both residential and commercial applications where surface mounting is required.

• Technical specifications

  Compatible sensors: 

  • SENMoLi/W & SENMoLi/B - Smart motion and light sensor
  • SENMax/W - Smart sensor for motion, light, and air quality

  CE: 

  • Qbus declares that this product complies with all applicable European directives and regulations.
  • The EU declaration of conformity is available upon request.

  Physical specifications:

  • Housing white variant: ASA plastic, UV-resistant, black variant: ABS plastic, self-extinguishing according to UL94-V0
  • Dimensions: (h x d) 50mm x 60mm
  • Weight: approximately 30g (built-in) – 100g (surface-mounted)
• Sizing

  • Dimensions: (h x d) 50mm x 60mm
• Explanation of symbols

  Equipment where protection against the risk of electric contact is not only based on basic insulation but also on additional protection such as double insulation or reinforced insulation. There is no possibility for grounding.

  Before connecting the device, it is mandatory to read the manual of the respective product. ISO7000-0434

  Power supply connection (230V) to the power supply connector. IEC 60417-5036

  CE conformity. All declarations of conformity are available upon request.

• Warranty provision

  Standard Warranty Period: 2 years from delivery date. The warranty is no longer valid if the module has been opened! Defective modules should be sent without seal along with a description of the defect to our service department:

  QBUS N.V. Joseph Cardijnstraat 19, 9420 Erpe-Mere, Belgium

  T +32 53 60 72 10 - F +32 53 60 72 19

  Email: [email protected]

General

• Safety Instructions

  Read the complete manual before installing and activating the SENTube.

  ATTENTION

  • The SENTube must be installed and maintained by a certified electrical installer in compliance with the applicable legal regulations of the country.
  • Keep out of reach of children.

Install and wire

• Installation

  • Pass the bus cable through the large opening on the back of the SENTube.
  • Cut the wires to the same height as the SENTube (50mm).
  • When connecting the bus, you will have a total of 8 cores.
  • Strip each core by 10mm.

  • For further connecting the wires, there are two options
    • Option A: use the bus cable provided with the sensor and twist the red with yellow wires together. Then twist the black with white wires together. Create a solder connection and place a heat shrink tube over the twisted wires.
    • Option B: use two Wago connectors to connect the red-yellow and black-white wires of the EIB cable and sensor bus cable.

  • Now mark the holes for the screws with a pencil
  • Drill the holes
  • Place the box against the ceiling or wall and secure it with two screws
  • Push the Wagos or soldered cable connections as far as possible into the surface-mounted housing.
  • Gently push the sensor into the surface-mounted housing. The sensor's springs should remain in the closed position (rest position) for this.

  Ensure that you do not press on the sensor surface. This may cause irreparable damage to the sensor.

• Power Supply

  The sensor is powered via the bus.

• BUS connection

  It is recommended to use the Qbus cable or any other cable with a minimum of 2 conductors of 1mm² as the bus cable. The green shielded EIB cable can also be used if the conductors are paired to achieve a minimum cross-section of 2 x 1mm².